product brief publication number 17-9200-02 international: connect one ltd. 2 hanagar street kfar saba 44425, israel tel: +972-9-766-0456 fax: +972-9-766-0461 e-mail: info@connectone.com http://www.connectone.com usa: connect one semiconductors, inc. 15818 north 9th ave. phoenix, az 85023 tel: 408-986-9602 fax: 602-485-3715 e-mail: info@connectone.com http://www.connectone.com copyright ? connect one ltd., august 2005. all rights reserved . iconnectorle ic100 low-cost wireless internet adapter general description: ic100 iconnectorle? is a low-cost version of connect one?s iconnector?. it is a small adapter that enables installed devices to easily and cost-efficiently connect to the internet via cellular modems and data- enabled cellular phones that use cdma, cdma2000 1xrtt, gprs, gsm and tdma networks. iconnectorle provides ?instant internet?? connectivity for installed legacy devices by eliminating the need for any hardware modification to the host device. the internet engine inside iconnectorle is connect one?s firmware-based ichip? co110pc internet controller?, which stores the internet protocol stack in updateable flash memory. simply install iconnectorle between your device and a cellular modem or data-enabled phone in order to internet-enable your host device. connect one?s at+i? protocol eliminates the need for internet programming and minimizes changes to the host application. the optionally available plug-and-play serialnet? mode of operation completely eliminates the need for changes to the host application, as it is a direct serial-to-internet port server. iconnectorle plugs into the host device?s serial port via a female db-9 connector or the evaluation extension board. it connects to the modem/phone via a male db-9 connector. iconnectorle is powered through pin 9 of the db-9 connector to the host device, or via an external power source applied to the evaluation extension board. application program interface: ? connect one?s at+i? protocol ? hayes at command set ? optional serialnet mode for transparent serial data- to-internet bridging wireless modem/ data-enabled phone support: ? works with wireless modems/data-enabled phones that support at commands via an rs-232 interface. internet protocols: ? standard protocols: ppp, ip, udp, tcp, http client, and dns ? optional additional protocols: smtp send and ftp send/receive clients (specify firmware version esft) ? optional serialnet mode: specify firmware version snet ? includes 10 simultaneous tcp or udp active sockets ? includes two listening sockets ? includes ras server hardware description: ? size: 53 x 33 x 17 mm (2.1 x 1.3 x 0.67 in.) shell only ? weight: 30g (1 oz.) ? operating humidity: 90% maximum (non- condensing) ? operating temperature: better than 0 to 70c (32 to 158 f) ? power supply input: 5-12 vdc ? current consumption: 75ma ? connectors: 2 db-9 male/female ? host interface: rs-232, power and ttl input ? modem interface: rs-232 performance sp ecifications: ? host data rate: up to 230 kbps. ? serial data format (at+i mode): asynchronous character; binary; 8 data bits; no parity; 1 stop bit. ? serial data format (serialnet mode): asynchronous character; binary; 7 or 8 data bits; odd, even or no parity; 1 stop bit. ? standard operating mode: full duplex; auto redial, tone dialing. ? flow control: hardware (dtr, rts, cts, dcd) and software flow control.
product brief publication number 17-9200-02 international: connect one ltd. 2 hanagar street kfar saba 44425, israel tel: +972-9-766-0456 fax: +972-9-766-0461 e-mail: info@connectone.com http://www.connectone.com usa: connect one semiconductors, inc. 15818 north 9th ave. phoenix, az 85023 tel: 408-986-9602 fax: 602-485-3715 e-mail: info@connectone.com http://www.connectone.com copyright ? connect one ltd., august 2005. all rights reserved . typical applications: before interne t-enabling before internet-enabling after internet-enabling after internet-enabling ordering information: iconnectorle: ic100-fm-i-1 evaluation extension board: IC-EVB-101-110/220 optional firmware versions: - esft: email send and ftp send/receive clients - snet: serialnet mode legend: ic100-ww-x-y where: ww = fm (female in/male out connectors) x = i for extended temperature range y = 1 when powered by pin 9 on db-9 connector ic-evb-101-x where: x = 110 or 220 volt power supply (please specify) ichip, internet controller, at+i, iconnector, iconnectorle, instant internet, serialnet and connect one are trademarks of conne ct one ltd.
|
